Browse

In old times, hydrotechnical constructions, mostly dams were built for the single purpose of water supply or irrigation. As civilizations developed, there was a greater need for water supply, irrigation, flood control, navigation, water quality, sediment control and energy. Demand for water is steadily increasing throughout the world. There is no life on earth without water, our most important resource apart from air and land. During the past three centuries, the amount of water withdrawn from freshwater resources...

The reliability of forecasted long-term peat settlement under embankment is primarily determined not by the soil models used, but by the specific features of peat laboratory testing. This article presents the results of oedometer tests of various-height peat samples with squeezing of pore water towards only top or top and bottom faces. The load was applied to the samples in two ways: by gradual stepwise increase or all at once. The stabilization condition for each load was sample deformation not exceeding 0.01 mm ...

The investigation of the fault tectonics in the Kovdor carbonatite intrusion (NW Russia) has resulted in the identification of a new brittle deformations type. It is formed due to the simultaneous turn of fissure planes at discrete angles around two orthogonal guiding lines (axes), where one is represented by a vertical massif symmetry axis (L1), and the other axis (L2) lies horizontally in the fracture plane. Nonetheless, the rotation along the both axes is codirectional, i.e., when moving counterclockwise around...

Defining the stability of a structure depends on several factors. It is difficult to predict them and take into account in the design phase. Over time, many of them will cause changes in the location of its components. Measurements are required to be taken during the operation of a structure in order to find out about any changes in its geometry. This paper contains an elaboration of the results of measurements of the geometry of a steel drum which is a major component of the historical roller gate dam - Czersko P...

When operating waterworks, it is required to refine the data on actual stresses in different structural elements of the facilities. The authors put forward a nonconventional approach to expanding the waterworks observation network. The quantitative assessment of stresses in a structural element at the given moment of time is performed using borehole techniques of geomechanics. Later on, the change in the stresses and deformations is controlled based on the data on deformation of sidewalls and damage of galleries u...