Browse

Existing industrial ammonia production installations operating in potentially explosive atmospheres usually contain a wide range of explosion protection concepts implemented during different stages of plant modernization and expansion. In such brownfield installations, the coexistence of equipment originating from different technological periods often leads to a non-uniform distribution of protection concepts at installation level. This aspect is particularly relevant for industrial sectors associated with oil and...

The presence of flammable and/or combustible substances in various industrial production processes generates in most cases potentially explosive atmospheres, which transforms a regular work environment into an explosion risk area, directly influencing the way in which equipment intended to be used in these areas is designed, installed and maintained. In areas where potentially explosive atmospheres may form due to the presence of flammable and/or combustible substances, technical equipment must be used whose casin...

Potentially explosive atmospheres constitute a major risk in the operation of industrial installations that use or generate gases, flammable vapours or combustible dust. According to ATEX legislation, explosions can occur as a result of the interaction between an explosive atmosphere and an active ignition source. Even under the conditions of using ATEX-certified equipment, the progressive degradation of the components can lead to the appearance of uncontrolled ignition sources. This paper analyzes from a technica...

Hydrogen is a promising energy carrier for future low-carbon systems, but its high flammability, wide explosion range, and low ignition energy present significant safety challenges. This paper proposes an integrated ATEX-based risk assessment methodology specifically designed for hydrogen storage and utilization systems. The methodology combines regulatory requirements, including EN 1127-1:2019, with a hydrogen-specific risk matrix, ATEX zone classification, and operational risk mitigation measures. A high-pressur...

Drilling fluid properties – density and rheology (plastic viscosity, yield point, gel strength) – are essential for wellbore stability, pressure control, hole cleaning, and minimizing non-productive time (NPT) in oil and gas drilling. Traditional manual methods (pressurized mud balance, Fann 35 viscometer) are periodic, labor-intensive, and delay corrections, increasing risks of kicks, lost circulation, and instability. This study proposes an intelligent automated system for real-time monitoring and control us...

In this paper is presented a Mobile Integrated System for on the Site Testing (MISST) of equipment intended for use in potentially explosive atmospheres, with type of protection pressurization p, resulting from research activities out by the research and testing team involved. The fundamental aspects of the design, implementation and easy use of such an integrated system have been examined, implemented and tested. A mobile integrated test system for Ex p type of protection applied to equipment in Ex construction, ...

Liquefied Petroleum Gas (LPG)-assisted retrofitting of diesel engines remains attractive, but exhaustive dual-fuel bench mapping is costly and engine-specific. This paper presents a simulation-guided prioritization workflow for retrofitting the UTB 2404055 agricultural diesel engine to LPG-diesel operation. An AVL BOOST 1D model of a dual-fuel architecture with multi-point LPG port injection and direct diesel pilot injection was calibrated and validated against eight measured diesel baseline points at 1400 and 240...